Welcome to Cangzhou Shengshiweiye Automobile Accessory Co.,Ltd!

Home > News Center > Company News

Product
News Center

Technical requirements of wheel weight

times   2018-10-03

Technical requirements of wheel weight

According to Shengshi Weiye Automobile Accessories CO.LTD, wheel weight is a standard weight component mounted on the car wheel . The function of the wheel weight is to make the car run at high speed and maintain the dynamic balance of the wheel assembly when the wheel rotates rapidly.

In static and low-speed rotation, uneven weight will affect the stability of the object's rotation. With the continuous improvement of road conditions in China and the rapid development of automobile technology, the speed of vehicles is also growing faster.If the weight is not uniform, in this high-speed driving process, not only will the ride comfort be affected, but also the abnormal wear of the car tire and the suspension system will be increased. When the vehicle runs off and the steering machine is trembling, the car will be increased during driving. The difficulty of the driver's control of the car leads to unstable driving.When the vehicle runs off and the steering machine is trembling, the car will be increased during driving. The difficulty of the driver's control of the car leads to unstable driving. In order to avoid this, the wheel must be tested for dynamic balance by a special device before installation.- the wheel balancer machine, Install wheel balance weight according to displayed gram on the wheel weight deviation, so that

maintenance dynamic balance under high-speed rotation, and maintenance vehicle stable and comfortable. This is the wheel balance weight.

Wheel balance weight technical requirements:

1. The wheel weight no cracks, pinholes, shrinkage or other defects affecting strength. The clips are not allowed to have cracks, burrs and elastic defects. The heat treatment hardness is HRC40~48, and the surface treatment is galvanizing, epoxy coating . The salt spray test reaches 120h, and it can reach 500h if it is treated with Dacrometed coated .

2. Find the balance point, install wheel balance weight on the balance point of the wheel rim, and use the installation tool (usually wheel weight plier) to strike the top of the hook so that the wheel balance weights hook and the block completely match the rim.

3. The thickness of the galvanized layer of the clip is 0.025mm, which fully meets the anti-corrosion requirements.

4. The wheel balance weights disassemble force is 300N.


Copyright © 2007-2015 Shengshiweiye Auto Parts Co., Ltd.