Welcome to Cangzhou Shengshiweiye Automobile Accessory Co.,Ltd!

Home > News Center > Company News

Product
News Center

The installation method of the clip-on wheel balance weight

times   2018-12-12

The installation method of the clip-on wheel balance weight

1)Using the clear cloth or deer skin to clean the inside and outside of the wheel rims after checking  the wheel dynamic balance to make sure the surface of the wheel hub have no oil and water .

2)The inspection before installing the clip-on balance weight :

aThere is no crack, pinhole, shrinkage cavity and any other imperfection that could effect the strength .
bThe end of clamping piece have no crack and burr.

 

3)Find the balance point and install the balance weight on this point of the wheel rim . Then use installing tools (usually the wheel weight pliers) to knock on the top of the balance weight to make sure the hook and body fit the wheel rim completely.


4)Check whether the balance weight is less crowded after installation. If not, it means we finish the installation successfully.


The decisive factor of whether the clip-on wheel weight can be used:

1)Whether the diameter of steel rim can match the diameter of the wheel weight model completely (whether radian can match ).

 


2)The opensize of wheel weight hook on the steel wheel rim is 2.0mm+/-0.2mm;

The opensize of wheel weight hook on the alloy wheel rim is 4.0mm+/-0.2mm; sometimes the special size of 4.5~5.0+/-0.2mm is required.



Copyright © 2007-2015 Shengshiweiye Auto Parts Co., Ltd.